/ SuperJet -Bottom discharge
/ Kompak series
Kompak-2 is the typical machine for trials and production, below
Standard Kompak-2 version is addressed to fine chemical and cosmetics
In production since 1989, this machine was repeatedly improved
in terms of versatility and compactness.
Major part of the process equipment are located inside the stainless
It employs the simplified, SJM2
SuperJetmill that has fewer components. The grinding angle
is determined for the range of specified products. The product
contact parts are made of AISI 304 stainless steel.
Kompak-2 has been manufactured in several, slightly different
versions (K2C-K2G) During the last decade.
The modular design allows customization and interchangeability
of different components such as the product feeding system, the
microniser, the product collecting bin and a wide choice of (
optional) process controls.
All versions and construction models feature the following components:
SJM2-series, bottom discharge, that allows the direct collection
of the product from the grinding chamber.
It has a nozzle ring with optimized grinding angles, a horizontal
venturi feeding system that avoids metal contamination and built-in,
static classifying system that assures very narrow, particle
Twin-shaft feeder, volumetric type, with concave-profile, self-cleaning,
screws, able to break the agglomerates and to assure an accurate
feeding of poor flowing products, for the whole batch.
The feedrate is controlled by a stepless, mechanical, speed
High-efficiency, dust separator combining inertial and static
effects. It is equipped with a membrane filter cartridge, reverse-pulse,
automatic cleaning and final, safety HEPA that exhausts breathing
air quality to the atmosphere.
Standard controls, integrated in the front panel, include process
pressure regulators, pressure gages and differential gages to
monitor the filters.
stainless steel construction, bright finish, internal parts
hand polished to 360 grit, Ra 0.32µm
With this modular design, all versions can be equipped with the following
- automatic controls
and sound alarm that monitor continuously the factory air supply
and the process lines and stop the operation in case of failure
electronic pressure controls that monitor the microniser with
proportional pressure regulators, specifically dimentioned for
very quick response and steady operation
- synoptic and
LCD-alarm display with fault messages in plain english, to signal
pressure drops on the microniser lines and across the filters
- electronic motor
controller allowing stepless regulation of feed speeds across
the specified range and features current limiting to prevent overloading
- vacuum compensation
system that avoids environment contamination in case of blow-backs.
internal linings include PTFE, polyurethane, boron carbide and
hard-metal alloys, etc.
0.4 - 38 kgs/hr
0.9 - 85 lbs/hr
Air consumption @ 7 barg
3 m3/min (110 scfm)
Compressed air supply
6-10 barg (85-145 psi)
Power supply 220/240V
0.45 kW (0.6 HP)
1.0 x 1.1 x 1.6(H) mt
Shipping: 230 kgs
1.3 x1.2 x1.9(H) mt
updated 08-Oct-2002. Copyright
� 2002 APTM SA Switzerland. All rights reserved